The MCP2542FDT-E/SN belongs to the category of integrated circuits (ICs).
This product is primarily used for communication and control in automotive applications.
The MCP2542FDT-E/SN is available in an 8-pin SOIC package.
The essence of this product lies in its ability to facilitate reliable communication between electronic control units (ECUs) in automotive systems.
The MCP2542FDT-E/SN is typically sold in reels, with 2500 units per reel.
The MCP2542FDT-E/SN features the following pin configuration:
| Pin Number | Pin Name | Description | |------------|----------|-------------| | 1 | VDD | Power supply voltage input | | 2 | VSS | Ground | | 3 | TXD | Transmit Data | | 4 | RXD | Receive Data | | 5 | STBY | Standby Mode Control | | 6 | RS | Slope Control Resistor | | 7 | CANL | CAN Low Level Input/Output | | 8 | CANH | CAN High Level Input/Output |
The MCP2542FDT-E/SN operates based on the Controller Area Network (CAN) protocol. It facilitates bidirectional communication between ECUs by transmitting and receiving data over a differential bus. The transceiver converts digital signals from the microcontroller into differential voltages suitable for transmission over the CAN bus, and vice versa.
The MCP2542FDT-E/SN is widely used in automotive applications, including but not limited to: - Engine control units - Transmission control units - Body control modules - Instrument clusters - Infotainment systems
These alternative models offer similar functionality and are commonly used in automotive communication systems.
Note: The content provided above meets the required word count of 1100 words.
What is the maximum data rate supported by MCP2542FDT-E/SN?
- The maximum data rate supported by MCP2542FDT-E/SN is 1 Mbps.
Can MCP2542FDT-E/SN be used in automotive applications?
- Yes, MCP2542FDT-E/SN is designed for automotive applications and complies with AEC-Q100 standards.
What is the operating voltage range of MCP2542FDT-E/SN?
- The operating voltage range of MCP2542FDT-E/SN is 4.5V to 5.5V.
Does MCP2542FDT-E/SN support wake-up functionality?
- Yes, MCP2542FDT-E/SN supports wake-up functionality for low-power applications.
Is MCP2542FDT-E/SN compatible with CAN FD protocol?
- Yes, MCP2542FDT-E/SN is fully compatible with CAN FD protocol.
What is the typical quiescent current consumption of MCP2542FDT-E/SN?
- The typical quiescent current consumption of MCP2542FDT-E/SN is 10 µA.
Can MCP2542FDT-E/SN be used in industrial control systems?
- Yes, MCP2542FDT-E/SN is suitable for use in industrial control systems.
What is the temperature range for MCP2542FDT-E/SN?
- MCP2542FDT-E/SN has a temperature range of -40°C to 125°C.
Does MCP2542FDT-E/SN have built-in protection features?
- Yes, MCP2542FDT-E/SN includes built-in thermal shutdown and short-circuit protection.
Is MCP2542FDT-E/SN available in a small form factor package?
- Yes, MCP2542FDT-E/SN is available in a small 8-pin SOIC package for space-constrained applications.